Passat Sedan 4Motion V6-3.6L (BLV) (2007)
/Page-3512001.png)
Trunk / Liftgate Shock / Support: Procedures
Rear Lid
Gas Strut, Venting
-
Clamp gas-filled strut in vice area - x - = 50 mm (2 in.).
CAUTION!
Only clamp the gas strut in area - x -. Otherwise, an accident may occur.
Always wear eye protection when sawing.
-
Saw into the cylindrical part of strut in the first third of the total cylinder length, determined starting from the edge of the cover on the side with the
piston rod.
‹› Cover the area of the sawn portion with a clean rag.
‹› Dispose of the oil and rag properly.
