Passat Sedan 4Motion V6-3.6L (BLV) (2007)
‹› Functional check:
-
With engine switched off, depress brake pedal firmly several times (to exhaust the vacuum in the unit).
-
Depress and hold brake pedal with average foot pressure and start engine. If brake booster is working properly, pedal will be felt to give
noticeably under foot (booster assist becomes effective).
‹› Replace as a unit in the event of malfunction (previously, check all vacuum lines).
‹› Removing and installing, refer to => [ Brake Booster ] See: Brake Booster
5
Seal
6
Brake Booster Vacuum Sensor (G483)
‹› Only on vehicles with the hydraulic brake booster
‹› Removing and installing, refer to => [ Brake Booster Vacuum Sensor ] See: Brake Booster Vacuum Sensor/Service and Repair/Brake Booster
Vacuum Sensor
7
Dual Master Brake Cylinder
‹› Cannot be serviced. Replace as complete unit if malfunctioning.
‹› Removing and installing, refer to => [ Brake Master Cylinder ] See: Hydraulic System/Brake Master Cylinder/Service and Repair/Brake
Master Cylinder
8
Brake Light Switch (F)
‹› Removing and installing, refer to => [ Brake Lamp Switch ] See: Lighting and Horns/Brake Light Switch/Service and Repair
9
Inner TORX(R) Bolt
‹› 5 Nm
10
Heat Shield
11
Self-Locking Hex Nut
‹› Always replace after removal
‹› 25 Nm
12
Brake Line
‹› 8.5 mm diameter -17 Nm
‹› 6 mm diameter - 14 Nm
‹› Master brake cylinder/secondary piston circuit to hydraulic unit
13
Brake Line
‹› 8.5 mm diameter - 17 Nm
‹› 6 mm diameter - 14 Nm
‹› Master brake cylinder/primary piston circuit to hydraulic control unit
14
Sealing Plugs
‹› Coat with brake fluid and press into brake fluid reservoir
15
Brake Fluid Reservoir