Passat Sedan 4Motion V6-3.6L (BLV) (2007)
Sealing Flange, Engine Front: Locations
Sealing flange and drive plate, assembly overview
Note:
^
Engine is to be secured to Engine and Transmission Holder VAS 6095 for performing assembly work.
1. 100 Nm plus an additional 1/2 turn (180°)
^
Replace
^
Turning further may be performed in several stages
^
Use retainer T10069 to loosen and tighten
2. Vibration damper
^
To remove and install, secure using counter-holder tool T10069
3. 10 Nm
4. Sealing flange
^
Coat sealing surfaces with sealant D 176 501
5. Cylinder block
6. Sealing flange
^
Apply sealant D 176 501 on sealing surfaces
7. Seal
^
Remove using pulling hook T20143/2
^
PTFE version of oil seal
^
Do not oil or grease sealing lip of oil seal.
^
Before installing, remove oil remains from crankshaft journal with a clean cloth
8. Shim
9. 60 Nm plus an additional 1/4 turn (90°)
^
Replace
^
To loosen and tighten, use retainer T10044 (with 5 mm spacers) or counter-holder tool T10069.
10. Washer
11. Drive plate
12. 23 Nm