Passat Sedan 4Motion V6-3.6L (BLV) (2007)
-
Remove the ribbed belt pulley - 2 - from the A/C compressor.
Installing
Installation is performed in the reverse order; when doing this note the following:
‹› Clean the thread on the A/C compressor shaft of old locking compound before installing
‹› Clean the A/C compressor flange before mounting the ribbed belt pulley.
‹› Install the circlip on the proper side, the side with beveled insertion edge faces away from A/C compressor (install flat side facing compressor).
‹› Replace the hex bolt - 5 -. Refer to => [ Ribbed Belt Pulley, Zexel ] See: .