Passat Sedan 4Motion V6-3.6L (BLV) (2007)
/Page-3972005.png)
Further installation is performed in reverse order. When doing this note the following:
‹› Only lubricate the seal with fuel when installing the flange
-
Note the flange location - B -:
The mark on the flange must align with the mark on the fuel tank - arrow -.
‹› The mark on the fuel tank is difficult to see.
B Fuel level sensor 2 flange
-
Install and tighten the locking ring using (T10202). Tightening specification: 110 Nm.
-
Note the location of the cover - B -:
