Passat Sedan 4Motion V6-3.6L (BLV) (2007)
-
Check wire between test box and 10-pin connector to Engine Control Module (ECM) for open circuit according to wiring diagram.
Terminal 2 + socket 27
Wire resistance: max. 3.0 ohms
-
Also check the wire for short circuit to B+ and to Ground (GND).
Specified value: infinity ohms
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code.
If no malfunction is detected in the wire and the voltage supply was OK:
-
Replace Fuel Pump (FP) Control Module -J538-.
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code.