Passat Sedan 4Motion V6-3.6L (BLV) (2007)
Function test
-
Perform the function test in Diagnostic Mode 06. Refer to => [ Diagnostic Mode 06 - Read Test Results for Specific Diagnostic Functions ] See:
Computers and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09.
-
Switch the ignition off.
If the specified values were not obtained:
Start Diagnosis
-
Disconnect the HO2S Oxygen Sensor Bank 1 Sensor 1 (G39) electrical harness connector - 2 -.
Checking primary voltage
-
Using a multimeter, check the HO2S Oxygen Sensor Bank 1 Sensor 1 (G39) electrical harness connector terminals 1 to 5 for voltage.
Specified value: 0.40 to 0.50 V
-
Switch the ignition off.
If the specified value was obtained:
-
Replace the HO2S Oxygen Sensor Bank 1 Sensor 1 (G39).
If the specified value was not obtained: