Passat Sedan 4Motion V6-3.6L (BLV) (2007)
Transmission Position Switch/Sensor: Testing and Inspection
Multi-Function Transmission Range (TR) Switch, checking
Recommended special tools and equipment
-
V.A.G 1526 multimeter or V.A.G 1715 multimeter
-
V.A.G 1594 connector test kit
-
Wiring diagram
Test requirements
-
Corresponding fuses on fuse holder in instrument panel, left side, for Multi-Function Transmission Range (TR) Switch -F125- must be OK.
NOTE: Fuses on this fuse holder are labelled "SC" in the wiring diagram.
-
Instrument Cluster Control Module -J285- must be OK.
-
Battery voltage must be at least 11.5 Volts.
-
All electrical consumers such as, for example, lights and rear window defroster must be switched off.
-
Selector lever must be in -P- position.
-
Ground (GND) connections to transmission must be OK.
-
Ignition switched off.
Function test
-
Observe safety precautions.
-
Observe rules for cleanliness.
-
Switch ignition on.
-
Depress brake pedal and maintain depressed.
-
Shift into all selector lever positions.
-
Selector lever position must correspond to display of Instrument Cluster Control Module -J285-.
-
Switch ignition off.
If selector lever position does not correspond to display of Instrument Cluster Control Module -J285-: