Passat Sedan 4Motion V6-3.6L (BLV) (2007)
-
Remove front seat backrest. Refer to => [ Left Front Seat Backrest ] See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Front Seats
-
Cover and upholstery, front seat cushion, removing and installing. Refer to => [ Front Seat Cushion ] See: Body and Frame/Seats/Service and
Repair/Overhaul/Seat Upholstery, Covers/Front Seat Cover and Upholstery
‹› Removal of seat occupied sensor is described for Trendline and Comfortline equipment lines. Removal is performed accordingly for Sportline
equipment line.
-
On seats with a massage-/ventilation function, remove cover - 1 - and loosen seat occupied sensor - 2 - from upholstery - 3 -.
-
On seats without massage-/ventilation function, loosen seat occupied sensor - 4 - from upholstery - 5 -.
Installation
Trendline and Comfortline equipment lines
-
Position flat wire - 1 - of Front Passenger's Seat Occupied Sensor (G128) into corresponding recess in center of upholstery.
-
Pull off adhesive strips - 2 - from Front Passenger's Seat Occupied Sensor (G128) - arrow A - on right side.
-
Adhere right sensor strip - 3 - of Front Passenger's Seat Occupied Sensor (G128) on to upholstery.
-
Pull off adhesive strips - 4 - from Front Passenger's Seat Occupied Sensor (G128) - arrow B - on left side.
-
Adhere left sensor strip - 5 - of the front passenger seat occupant sensor (G128) to the upholstery.
‹› While adhering, make sure that sensor strips are aligned so that they run parallel to recess in upholstery.