Passat Sedan 4Motion V6-3.6L (BLV) (2007)
-
Check the wiring for an open, high resistance or short circuit to Battery (+)
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If the specified value was obtained:
-
Using a multimeter, check terminal 4 of the MAF / IAT sensor to engine ground.
Specified value: 1.5 ohms Max
If the specified value was Not obtained:
-
Check the wiring for an open circuit or high resistance.
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is detected in the ground circuit:
-
Replace the Motronic Engine Control Module (ECM) (J623). Refer to the Repair Information.
°Testing if display approx. 140 C:
-
Disconnect the MAF / IAT sensor (G70 / G42) electrical harness connector.
-
Check the value indicated on the scan tool display.
If indication jumps to approx. -40° C or -46° C:
-
Switch ignition off.
-
Replace the MAF / IAT sensor (G70 / G42) Refer to the Repair Information.
If the indication remains at approx. 140° C
If the manufacturers test box is being used, perform the following step.
-
Install the test box.
If the manufacturers test box is not being used, perform the following step.
-
Remove the Motronic Engine Control Module (ECM) (J623). Refer to the Repair Information.
-
Disconnect the ECM harness.
-
Using a multimeter, check the MAF / IAT sensor (G70 / G42) electrical harness connector terminal 5 to engine ground.
Specified value: OL or no continuity.
If the specified value was Not obtained:
-
Check the wiring for a short circuit to ground.
-
If necessary, repair the faulty wiring connection.
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
If no malfunction is detected in the wiring and the sensor resistance was OK:
-
Replace the Motronic Engine Control Module (ECM) (J623). Refer to the Repair Information.
Final procedures