Passat Sedan 4Motion V6-3.6L (BLV) (2007)
-
Disconnect 6-pin connector -arrow- from Throttle Position (TP) Sensor.
Checking voltage supply
-
Switch ignition on.
-
Connect multimeter with test leads to the following connector terminals for voltage measurement.
Terminal 1 + Ground (GND)
Terminal 1 + 5
Terminal 2 + Ground (GND)
Terminal 2 + 3
Specified value: at least 4.5 V
-
Switch ignition off.
If there is no malfunction in voltage supply:
-
Check wires to Engine Control Module (ECM) according to wiring diagram.
Checking wires to Engine Control Module (ECM)
-
Connect test box to 94-pin connector of wiring harness, connecting test box for wiring test.
Engine Control Module (ECM) is not connected.
-
Check wires between test box and 6-pin connector to Engine Control Module (ECM) for open circuit according to wiring diagram.
Terminal 1 + socket 58
Terminal 2 + socket 80