Passat Sedan 4Motion V6-3.6L (BLV) (2007)
^
Install six wires using Part No: 000979019A.
^
Seal terminals with yellow terminal seal Part No: 3B0972742B.
^
Tape the six wires and remaining harness wires together - 1- using 5 cm (2 in.). of electrical tape Part No: 000979950.
^
Shorten wires by approximately 4 cm (1.5 in.) and arrange them/mark them so that one wire leads to each pin.
^
Shortest wire should lead to pin 1 and longest wire should lead to pin 6.
^
Connect individual wires using splice connectors Part No: 111971941A.
Tip:
Use crimping tool VAS1978/1-1.
^
Secure wires -1- using electrical tape Part No: 000979950.
^
Reconnect original corrugated tube -2-.
^
Install a new corrugated tube -3- Part No: N90773501.
Tip:
Ensure that the corrugated tube overlaps both ends of exposed harness.
^
Install protective cap -4- Part No: 021971921.
^
Install new T-connector Part No: N90669501 on corrugated tube.
Tip:
Make sure that ends of corrugated tubes overlap in T-connector and are locked tight.
^
Install clip Part No: 4A0820199 at locations -1- and -2- above