Passat Sedan 4Motion V6-3.6L (BLV) (2007)
-
Replace the bolts of the mounting bracket one after the other on both sides using (T10096) and tighten them to 20 Nm.
Subframe, Securing
-
Replace the front bolts of the subframe one after the other using (T10096) and tighten to 20 Nm.
Position of front axle is now secured.
Continue with removing stabilizer. Refer to => [ Remove the stabilizer from subframe and ] See: Stabilizer Bar/Service and Repair/Front
Suspension/Stabilizer Bar.
Steering Gear, through MY 2008, removing, refer to => [ Place under
subframe. ] See: Steering/Steering Gear/Service and Repair/Removal and Replacement/Steering Gear, Through MY 2008.
Steering Gear, from MY 2009, removing, refer to => [ Place under
subframe. ] .
Continue removing the subframe without the steering gear. Refer to => [ Now remove the bolts for: ] See: Cross-Member/Front
Cross-Member/Service and Repair/Subframe Without Steering Gear.
Continue removing the subframe with the steering gear. Refer to => [ Place the under
the subframe. ] See: Cross-Member/Front Cross-Member/Service and Repair/Subframe With Steering Gear.
Removing (T10096)
Removal is performed in the reverse order of installation. Make sure that the (T10096) are replaced one after the other with new bolts.
Tightening Specifications, Subframe to Body