Passat Sedan 4Motion V6-3.6L (BLV) (2007)
Rear Subframe Mount: Service and Repair
Steel Subframe Bonded Rubber Bushings
All Wheel Drive (AWD)
Steel Subframe Bonded Rubber Bushings
Special tools, testers and auxiliary items required
‹› Tensioning strap (T10038)
‹› Locating pins (T10096)
‹› Assembly tool (T10263)
‹› Engine/transmission jack (V.A.G 1383 A)
‹› Hydraulic Press (VAS 6178) with Pressure Head (T10205/13)
‹› Hollow piston cylinder (VAS 6179)
Front Bonded Rubber Bushing, Removing
-
Remove rear wheels.
-
Remove coil springs. Refer to => [ Coil Spring ]. See: Service and Repair/Removal and Replacement/Rear Suspension/All Wheel Drive
(AWD)/Removal and Installation/Coil Spring
-
Remove exhaust system rear muffler.
-
Disconnect electrical connections between subframe and body.
-
Remove the stabilizer bar. Refer to => [ Stabilizer Bar ]. See: Service and Repair/Removal and Replacement/Rear Suspension/All Wheel Drive
(AWD)/Removal and Installation/Stabilizer Bar
-
Remove tie rods. Refer to => [ Tie Rod ]. See: Service and Repair/Removal and Replacement/Rear Suspension/All Wheel Drive (AWD)/Removal
and Installation/Tie Rod
-
Remove the clip - 1 -.
‹› Do not disconnect the brake line.
-
Now secure vehicle on both sides to lifting arms on hoist with (T10038).