Passat Sedan 4Motion V6-3.6L (BLV) (2007)
/Page-2754004.png)
6
Spindle (T10263/4)
-
Pretension special tools.
-
Pull out bonded rubber bushing by operating pump.
‹› The bearing outer race is sheared off when the bonded rubber bushing is removed. There is a loud crack when this happens.
-
After removing the rubber bonded bushing, it must then be removed from the tube (T10356/6)
-
Mount the (T10356/6) on the provided surfaces in a vice.
-
Pry a screwdriver between the (T10356/6) and the rubber bonded bushing - arrow - and, if necessary, remove the bushing by tapping lightly with
a hammer on the drift.
Pull in Front Bonded Rubber Bushing
Installation is performed in the reverse order of removal. Observe the following when doing so:
Distinguishing characteristic, rubber bonded bushing
