Passat Sedan 4Motion V6-3.6L (BLV) (2007)
-
Check resistances of solenoid valves at connector to the solenoid valves:
NOTE: Resistance value is valid at approx. 20 degrees C. At higher temperatures, resistance value increases.
If one of the specified values is not obtained:
-
Replace the relevant solenoid valve.
-
Erase DTC memory of Transmission Control Module (TCM), Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code.
If specified values are obtained:
-
Check wires to Transmission Control Module (TCM) according to wiring diagram.
Checking wires to Transmission Control Module (TCM)
-
Connect test box to control module wiring harness, connect test box for wiring test. See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Component Tests and General Diagnostics/Component Tests (VAG Code Tests)/Test Box, Connecting For
Wiring Test
-
Check wires between test box and 14-pin connector to Transmission Control Module (TCM) for open circuit according to wiring diagram.
Wire resistance: max. 3.0 ohms