Passat Sedan 4Motion V6-3.6L (BLV) (2007)
-
Remove the tunnel bridge and disconnect the exhaust system at the clamping sleeve. Refer to - arrows -.
-
Detach rear muffler on retaining loops and remove rear part of exhaust system.
-
Remove the front exhaust pipe.
-
Remove the heat shield - arrows - below the driveshaft.
-
Support the driveshaft in the area of the rear driveshaft tube with the engine and transmission jack (V.A.G 1383 A) and a block of wood - A -.
-
Secure the driveshaft against falling down with a strap from the universal transmission support (V.A.G 1359/2).
-
Mark the position of the driveshaft flexible disc to the bevel box output flange.