Passat Sedan 4Motion W8-4.0L (BDP) (2002)
/Page-1418010.png)
^
Pressing piston back.
^
Insert brake pads.
^
Swing brake caliper housing down and secure with new self-locking bolt.
^
Remove upper brake caliper housing securing bolt. Counter hold on guide pin.
^
If removing the upper brake caliper housing securing bolt, it must always be replaced.
^
Bolt on brake caliper housing, Refer to Front / C54 Brake Caliper, Servicing, Overview, See item 4.
^
Insert brake wear indicator connector into bracket on brake caliper.
The brake wear indicator wiring must be routed between the brake carrier and brake line.
Note:
^
The repair kit includes four self-locking hex bolts which must be installed.
^
After changing each brake pad and with vehicle stationary. Firmly depress brake pedal several times so that the brake pads are properly seated in
their normal operating position.
^
Check brake fluid level, after changing brake pads.
Overview
FN3 brake caliper, servicing
Special tools and equipment
