Passat Sedan 4Motion W8-4.0L (BDP) (2002)
Vacuum Pump: Testing and Inspection
Checking brake vacuum pump -V192-
Special tools and equipment
^
VAS 5051 Vehicle diagnosis, testing and information system
^
Diagnosis cable VAS 5051/1 or VAS 5051/3
Work sequence
^
With ignition switched off, connect tester VAS 5051 to diagnosis cable VAS 5051/1 or VAS 5051/3.
^
Switch on tester -arrow-.
Now the tester requires approximately 3 minutes to warm up.
^
Switch on ignition.
^
Select mode of operation: press button on touch screen for "On Board Diagnostic (OBD)".
^
Select vehicle system: select "01 - Engine electronics" on display.
The control module identification and the coding are indicated in the upper right-hand corner of the display.
^
Select diagnostic function: at this point, all diagnostic functions are available.
^
Select "04 - Basic setting" on the display.
^
Press keys 0, 0 and 8
^
Confirm entry with key Q.
Displayed on the screen:
^
Depress brake pedal hard several times in concession until the test is activated.
Displayed on the screen: