Passat Sedan 4Motion W8-4.0L (BDP) (2002)
/Page-479007.png)
Note: Observe installation position of bearing caps:
^
Points of bearing caps -A- of intake and exhaust camshafts face outward.
^
Identification on bearing caps is legible when read from the intake side.
A - Intake camshaft
^
Tighten bearing caps 23 and 27 alternately and diagonally to 5 Nm and 1/8 turn (45°) further.
^
Install bearing cap 25 and tighten to 5 Nm and 1/4 turn (45°) further.
^
Install bearing caps 21 and 29 and tighten to 5 Nm and 1/4 turn (45°) further.
B - Exhaust camshaft
^
Tighten bearing caps 24 and 28 alternately and diagonally to 5 Nm and 1/4 turn (45°) further.
^
Install bearing cap 26 and tighten to 5 Nm and 1/4 turn (45°) further.
^
Install bearing caps 22 and 30 and tighten to 5 Nm and 1/4 turn (45°) further.
Cylinder banks 1 and 2
^
Position camshafts in cylinder heads to TDC No. 1 cylinder.
Note: Camshaft bar T10068 must engage in both shaft grooves.
