Passat Sedan 4Motion W8-4.0L (BDP) (2002)
Drive Belt: Procedures
Ribbed Belt - 8-cyl. Engine, Removing And Installing
Removing
CAUTION: Before removing ribbed belt, mark direction of rotation. Belt damage will result if not reinstalled in proper direction.
-
Bring front end assembly (lock carrier) into service position See: Body and Frame/Lock Carrier/Service and Repair/Procedures
-
Fit 30 mm wrench at hex surface -1- and rotate tensioner in direction of -arrow- until ribbed belt loosens.
-
Remove ribbed belt.
Installing
-
Fit ribbed belt over all pulleys except coolant pump pulley.
Ribbed belt routing. Refer to Ribbed belt, routing diagrams
-
Fit 30 mm wrench at hex surface -1- and rotate tensioner in direction of -arrow-
-
Route ribbed belt onto coolant pump pulley
CAUTION:
-
After installing ribbed belt, check for proper seating and alignment in all pulleys.
-
Start engine and check belt running.