Passat Sedan 4Motion W8-4.0L (BDP) (2002)
/Page-496001.png)
Drive Belt: Testing and Inspection
Ribbed Belt - 8-cyl. Engine, Checking
Proceed as follows:
-
Lift vehicle and remove lower sound deadening cover (where applicable).
-
Fit wrench to vibration dampener/pulley and turn so that entire length of ribbed belt running and flank surfaces are visible.
-
Check ribbed belt -1- for:
-
Pitting and lateral or lengthwise cracks in ribbed belt running (contact) surfaces
-
Lengthwise cuts, loose strands
-
Pieces missing, separation, breaks in running surfaces
-
Belt reinforcement (flank surface) fraying
-
Flank and running surface wear, glazing, ribbed belt material deposits on pulley running (contact) surfaces
-
Oil or grease deposits
NOTE: If ribbed belt is damaged, replace immediately to prevent failure or improper function of driven components.
