Passat Sedan 4Motion W8-4.0L (BDP) (2002)
/Page-547002.png)
^
Do not additionally oil or grease the oil seal sealing lip
^
Before installing, remove oil remains from crankshaft journal with a clean cloth
^
Replacing, Refer to Seals and Gaskets, Engine, Front Crankshaft Seal, Service and Repair
8. Aluminum cylinder block
9. 20 Nm
^
Observe sequence when tightening 1
10. Sealing flange
^
Clean sealing surface before installing
^
Coat sealing surfaces to cylinder block with sealant D 188 800 A1
^
Sealing sealing surfaces to covers, Refer to Intake/Exhaust Valve, Adjustment. Adjusting timing
11. Seal
^
Replace only in conjunction with rear sealing flange item 10
12. 10 Nm
^
Observe sequence when tightening - Fig. 1
13. Oil seal
^
PTFE version of oil seal
^
Identification: no inner coil spring
^
Do not additionally oil or grease the oil seal sealing lip
^
Before installing, remove oil remains from crankshaft journal with a clean cloth
^
Replacing, Refer to Seals and Gaskets, Engine, Crankshaft Main Bearing Seal, Service and Repair
14. Dual-mass flywheel/drive plate
^
Removing and installing drive plate, Refer to Transmission and Drivetrain, Flywheel M/T, Service and Repair
15. Bolt
^
Counter-hold with T10069 to loosen and tighten
^
Replace
^
Two-mass flywheel: 60 Nm + 1/2 turn (180°) further
^
Drive plate: 60 Nm + 1/4 turn (90°) further
Fig. 1 Tightening sequence of securing screws for sealing flange
Note: The cover must be installed within 5 minutes of applying sealing compound.
^
Tighten screws in sequence indicated as follows and note different screw lengths.
