Passat Sedan 4Motion W8-4.0L (BDP) (2002)
-
secure with spring type clamps
11
from connecting hose
12
Union nut, 60 Nm
-
Use wrench 3218 to remove and install
13
Connector
-
black, 2-pin
-
to Sender for fuel gauge
14
Flange
-
Note installation position at fuel tank Fig. 1
15
Seal
-
Replace if damaged
-
to install, place into opening of fuel tank dry
-
only coat with fuel when installing flange item 14
16
Fuel Supply Sensor 3 -G237-
17
Mounting clip
-
Check for secure fitting
18
Heat shield
-
for fuel tank
19
Connecting piece
-
to connecting hose of auxiliary fuel tank, item 7
20
23 Nm
21
10 Nm
22
Tension strap
-
Note installed position
23
Fuel Level Sensor 2 -G169-
24
Fuel tank
25
Return line
-
blue or with blue marking
-
Check for secure fitting
-
secure with spring type clamps
-
from fuel return line at fuel distributor (cylinder bank 2), Item 3
Fig. 1 Installation position of Fuel Pump (FP) flange
Marking on flange -1- must align with marking on fuel tank -2-.
NOTE: After installing Fuel Pump (FP) flange, check whether supply, return and vent lines are still clipped in at fuel tank.