Passat Sedan 4Motion W8-4.0L (BDP) (2002)
Camshaft Position Sensor: Service and Repair
Parts of ignition, removing and installing
NOTE:
-
Cylinder bank 1 is located on right side in direction of travel.
-
Cylinder bank 2 is located on left side in direction of travel.
-
Disassembling and assembling control housing Fig. 1.
1
Connector
-
Black, 4-pin
-
before disconnecting, mark allocation of connector to component
2
Face plate
-
for Camshaft Position (CMP) sensor
3
Camshaft Position (CMP) sensor*
-
before disconnecting, mark allocation of connector to component
-
Terminals of sensor and connector are gold-plated
Cylinder bank 1
-
Camshaft Position (CMP) Sensor -G40-= bank 1 intake camshaft
-
Camshaft Position (CMP) Sensor 2 -G163-= bank 1 exhaust camshaft
Cylinder bank 2
-
Camshaft Position (CMP) Sensor 3 -G300-= bank 2 intake camshaft
-
Camshaft Position (CMP) Sensor 4 -G301-= bank 2 exhaust camshaft
4
10 Nm
5
20 Nm
-
Tightening torque affects function of Knock Sensor (KS)
6
Knock sensors*
-
contact surfaces between knock sensor and cylinder block must be free of corrosion, dirt and grease
Component locations:
-
Knock Sensor (KS) 1 -G61-, black Fig. 2
-
Knock Sensor (KS) 2 -G66-, brown Fig. 2