Passat Sedan 4Motion W8-4.0L (BDP) (2002)
/Page-928002.png)
NOTE: Vehicle speed must not drop to below 5 km/h during test.
-
End road test and switch ignition off.
If no speed is indicated:
-
Connect test box to control module wiring harness, connect test box for wiring test. See: Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/Scan Tool Connecting/With Generic Scan Tool/Test Box, Connecting For Wiring Test
-
Remove instrument cluster
-
Check wiring connection from Engine Control Module (ECM, socket 43) to Control module with indicator unit in instrument panel insert.
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
