Passat Sedan 4Motion W8-4.0L (BDP) (2002)
-
Connect multimeter to the following connector terminals for voltage measurement.
Terminal 1 + Ground (GND)
Terminal 1 + 5
Terminal 2 + Ground (GND)
Terminal 2 + 3
Specified value: at least 4.5 V
-
Switch ignition off.
If specified values are not obtained:
-
Connect test box to control module wiring harness, connect test box for wiring test. See: Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/Scan Tool Connecting/With Generic Scan Tool/Test Box, Connecting For Wiring Test
-
Check wires between test box and 6-pin connector for open circuit according to wiring diagram.
Terminal 1 + socket 72
Terminal 2 + socket 73
Terminal 3 + socket 36
Terminal 4 + socket 35
Terminal 5 + socket 33
Terminal 6 + socket 34
Wire resistance: max. 1.5 Ohms
-
Also check wires for short circuit to each other, to vehicle Ground (GND) and to B+.
Specified value: Infinity Ohms
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If no malfunction is detected in the wiring and if the voltage supply was OK:
-
Replace Throttle Position (TP) sensor, item 4 .
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes