Passat Sedan 4Motion W8-4.0L (BDP) (2002)
/Page-989003.png)
-
Check wire between 2-pin connector terminal 1 and Ground (GND) for open circuit according to wiring diagram.
Wire resistance: max. 1.5 Ohms
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If no malfunctions are found in wires:
-
Replace Motronic Engine Control Module (ECM) -J220-.
