Passat Sedan 4Motion W8-4.0L (BDP) (2002)
-
Connect diode test lamp to the connector terminals of the fuel injector to be checked.
-
Operate starter and test activation of fuel injector.
LED should flicker.
-
Switch ignition off.
If LED does not flicker:
Checking wiring
-
Connect test box to control module wiring harness, connect test box for wiring test. See: Computers and Control Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/With Generic Scan Tool/Test Box, Connecting For Wiring
Test
-
Check wires between test box and 2-pin connector for open circuit according to wiring diagram.
Wire resistance: max. 1.5 Ohms
-
Also check wires for short circuit to B+ and Ground (GND).