Passat Sedan 4Motion W8-4.0L (BDP) (2002)
Cylinder Bank 2
Cylinder bank 1 and 2
-
Also check wires for short circuit to each other.
Specified value: Infinity Ohms
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If no malfunctions are found in the wires and there was voltage between terminals 1 + 3:
-
Replace the respective camshaft position sensor (Camshaft Position (CMP) Sensor -G40-, Camshaft Position (CMP) Sensor 2 -G163-, Camshaft
Position (CMP) Sensor 3 -G300- or Camshaft Position (CMP) Sensor 4 -G301-), item 3 .
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If no malfunctions are found in wires and there was no voltage between terminals 1 + 3:
-
Replace Engine Control Module (ECM).