Passat Sedan 4Motion W8-4.0L (BDP) (2002)
-
Install joint pins of track-control and guide links into wheel bearing housing.
-
Screw on new self-locking nut and tighten
Counter hold joint pin with 4 mm AF hex key if necessary.
-
Slide drive shaft outer joint pin into wheel hub and tighten new hex bolt hand tight.
-
Insert upper links into wheel bearing housing, insert new bolt and tighten new nut -2-.
When tightening press upper links downward as far as possible!
-
Install track rod.
-
Tighten hex bolt.
-
Screw on new self-locking nut and tighten.
-
Connect ABS vehicle speed sensor.
-
Screw on cover plate and tighten
-
Install disc brake, screw on brake caliper.
-
Install wheel and tighten.
-
Tighten drive shaft hex bolt.
Check and if necessary, adjust the front axle, alignment must take place on a VW/Audi recommended alignment stand.