Passat Sedan 4Motion W8-4.0L (BDP) (2002)
/Page-1305002.png)
-
VAG 1869/2 Brake pedal applicator
Note:
^
Before disassembling, note the relative position of all the parts to one another. Reassemble in the same position, otherwise the imbalance will be
too great. Imbalance may damage the bearings and generate humming noises.
^
Do not bend the driveshaft; store and transport in extended state.
Work on the driveshaft should be carried out on a two-column lifting platform.
Removing
-
Remove rear section of exhaust system.
-
Remove heat shield -A- from floor of vehicle.
-
Remove deflector-B- -arrows-.
-
Check driveshaft and flange/driveshaft on rear final drive to see whether a mark (red dot) is present.
-
If there is no dot, make a colored mark to indicate position of driveshaft flange -arrow A- relative to rear final drive -arrow B-.
Vehicles with tapped holes in front of rear final drive
