Passat Sedan 4Motion W8-4.0L (BDP) (2002)
-
Install hub -1- and hollow-piston cylinder -2- with pull rod on wheel bearing.
-
Install press piece -3- with shoulder to special nut -4- on inside.
-
Press in hub by operating the pump.
1. Hub
2. Hollow-piston cylinder HKZ-15
3. Press piece E-5
4. Special nut E-8-214 and pull rod
Further assembly work is carried out in the reverse order
Steel wheel bearing housing, removing and installing
Removing
-
Remove hex bolt for drive shaft.
-
Remove wheels.
-
Remove securing bolts -1- from brake caliper.
-
Remove brake caliper and hang up on body.
-
Take off disc brake.
-
Remove bolts for splash plate.
-
Take off splash plate.
-
Disconnect ABS vehicle speed sensor out from wheel bearing housing