volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Resetting Anti-Theft Radio|Page 9354 > < Initial Inspection and Diagnostic Overview|Page 9351
Page 1
background image

Radio/Stereo: Service and Repair
Resetting Anti-Theft Radio

Premium IV 10/97 Through 07/99

Anti-theft security coding

"Premium IV" 10-97 through 07.99 anti-theft security code, inputting

The security code is "fixed", meaning the radio is programmed by the radio manufacturer to accept only one code. This code must be input during the
new vehicle delivery inspection, into newly installed or existing units removed and reinstalled.

Prerequisites:

-

Obtain security code, either from code card or from customer.

-

Fuse 37 OK (S237 in wiring diagram)

Inputting code/cancelling electronic lock-up

-

Switch on radio
"SAFE" appears in radio display, followed by "1000" approximately 3 seconds later

-

Input the security code found on the radio card using the station preset buttons on the radio. Button "1" corresponds to the first number in the
security code, "2" the second and so on. Press the applicable button repeatedly until the desired number appears in the display (eg.: press button
"1" three times it the first number in the code is 3).

-

When the entire code has been input and appears on the display, press the right side of the "Seek" button (">") for longer then 2 seconds until an
audible signal is heard.

The code is input properly when the display indicates a radio frequency (ready for use). When the radio is switched off and the ignition key removed,
a flashing LED on the radio faceplate indicates the radio is security protected.

Incorrect code number

If an incorrect code is entered, "SAFE" will appear in the display (first blinking and then continuous) and the radio will not function. The entire coding
procedure can only be repeated one more time immediately (the number of attempts is displayed).

If during the second attempt an incorrect code is entered, the radio will lock-up for approximately one hour. Leave radio switched on for 1 hour and
attempt coding again when the number of attempts on display goes out (ensure proper code is available).

Cycle: 2 attempts - 1 hour lock-up still applies.

Premium V & VI (Incl. Monsoon) From 08/99

"Premium V & VI" (incl. "Monsoon") from 08.99 anti-theft security code, inputting

"Premium VI" and "Premium VI - Monsoon" are installed as a running change during m.y. 2001.

NOTE:

"Premium VI" radios are identified as "Premium CD" in the owner's literature.

The security code is "fixed", meaning the radio is programmed by the radio manufacturer to accept only one code. This code must be input during the
new vehicle delivery inspection, into newly installed or existing units that have been removed and reinstalled.

Prerequisites:

-

Obtain security code, either from code card or from customer.

-

Fuse 37 OK (S237 in wiring diagram)

Inputting code/cancelling electronic lock-up

-

Switch on radio
"SAFE" appears in radio display, followed by "1000" approximately 3 seconds later.

Resetting Anti-Theft Radio|Page 9354 > < Initial Inspection and Diagnostic Overview|Page 9351