Passat Syncro Sedan V6-2771cc 2.8L DOHC (AHA) (1999)
Preparing to pull in subframe bushing
-
Install tube 3372 and insert segments 3372/2.
Aligning bonded rubber bushing
The bonded rubber bushings must be aligned with a long square tube or a straightedge.
A = 90° ± 5°
Note: Always use protective jaw covers when clamping the subframe in a vise
Pulling in rear bonded rubber bushing
-
Coat bonded rubber bushing with tire mounting lubricant or similar.
-
Pull in bushing -A- until thrust piece 3372/1 aligns with upper edge of tool 3372.
-
Remove tool 3372 and segments 3372/2 in an upward direction.
Pulling in rear bonded rubber bushing
-
Insert tool segments 3372/2 between bridge 3351/4 and subframe.
-
Pull bushing in onto stop.