Passat Syncro Sedan V6-2771cc 2.8L DOHC (AHA) (1999)
If specified values are obtained:
Checking voltage supply
-
Pull connectors -1- off connection -2- of all fuel injectors.
-
Connect multimeter to terminals 1 + 2 of the disconnected connector for voltage measurement.
-
Operate starter
Specified value: at least 11.5 V
-
Switch ignition off.
If there is no voltage:
-
Check wire between 5-pin connector terminal 1 and relay carrier for open circuits according to wiring diagram.
Wire resistance: max: 1.5 Ohms
-
Check for open circuit in wire between 5-pin connector terminal 2 and Ground (GND) according to wiring diagram.
Wire resistance: max: 1.5 Ohms
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If specified values are obtained:
Checking activation
-
Pull connectors -1- off connection -2- of all fuel injectors.