Passat Syncro Sedan V6-2771cc 2.8L DOHC (AHA) (1999)
charging escape through a central opening on the side of the upper cover. The integrated flame trap prevents flammable gases in the battery from
igniting. The flame trap is comprised of a small round fiberglass mat with a diameter of 15 mm and a thickness of 2 mm. Working as a one-way-valve, it
allows gases produced during charging to vent.
-
Install hold-down bracket and torque M8 x 25 bolt -arrow- to 22 Nm (16 ft. lb.).
-
Connect positive B+ terminal to battery positive (+) post.
NOTE:
-
In order to prevent damage to the battery housing, battery terminals must be placed on battery posts without using force (by hand only).
-
Battery posts and terminals must no longer be greased.
-
Torque battery positive B+ post/terminal nut to 6 Nm (53 in. lb.).
-
Only after connecting positive B+ terminal, proceed to connect negative GND terminal -arrow- to battery negative (-) post.
-
Torque battery post/terminal nut -arrow- to 6 Nm (53 in. lb.).
CAUTION!
If battery is not secured properly, the following will result:
-
Shortened battery service life due to vibration damage.
-
Battery cell and plate damage.
-
Electrolyte leakage due to battery case damage.
-
Poor collision safety.
-
If present, reconnect central gas vent hose to top cover.
-
Reinstall cowl panel.