Passat Syncro Wagon V6-2.8L (ATQ) (2000)
Ignition Key In Signal: Service and Repair
Adaptation: Matching Ignition Keys To Radio Frequency Remote Control
NOTE:
-
If new or additional ignition keys are required they must be matched to the immobilizer and comfort system control electronics.
-
The matching procedure must always be carried out for all the ignition keys, including the existing ones.
-
The number of keys already matched will be displayed when the adaptation (matching) function is selected.
-
With the introduction of this generation of comfort system it is possible to program additional functions. The functions and the programming are
described.
-
The matching can be interrupted with the "C" key of the VAG 1551
WARNING!
The VAG 1551 dealership number (Dealership code) will be stored in immobilizer control module when matching ignition keys.
Test requirements
-
All ignition keys available. If no old ignition key is available see "Lost Key procedure",
-
Key fob with covered secret number is available, if nit see "Establishing secret number",
-
Insert correct profile ignition key in the ignition lock.
-
Connecting Scan Tool.
-
Initiating On Board Diagnostic (OBD).
Adaptation shown here is only an example.
Indicated on display
Rapid data transfer
HELP
Select function XX
-
Press keys -1- and -0- (selects function "Adaptation") .
Indicated on display
Rapid data transfer
Q
10 - Adaptation
-
Confirm with -Q- key.
Indicated on display
Adaptation
Enter channel number XX
-
Press keys -0- and -0- (all keys are erased with channel number 00).
-
Confirm with -Q- key.
NOTE: It is not possible to match a new or additional key(s) without erasing existing learned / matched key(s).
Indicated on display
Adaptation
Q
Erase learned values
-
Confirm with -Q- key.
Indicated on display
Adaptation
->
Learned values are erased
-
Press -> key.
Indicated on display