Passat Syncro Wagon V6-2.8L (ATQ) (2000)
Sunroof / Moonroof Motor: Service and Repair
Sunroof Drive Motor, Removing And Installing
Removing
-
Unclip cover - 1 - for drive motor.
Changing motor - detection of pre-selector switch:
NOTE:
-
In order to interrupt release signal and reby to activate switch detection, following conditions must be met.
-
If this is not case, it may lead to drive motor incorrectly detecting pre-adjuster, and position is not reached. If this happens, it must be realized that
it will remain stationary at a switch position approx. 10 cm short of actual closing position.
CAUTION:
-
Only remove and install drive motor for sunroof glass panel when roof is closed ("0" position).
-
Engine and ignition off, remove key and open door.
-
This state must be maintained up to installation of drive motor.
-
Unclip and disconnect harness connector.
-
Remove bolts - arrows - and remove drive motor for sunroof.
bolts for drive motor are micro-encapsulated and must always be replaced 3.5 Nm.
Installing
Installation is reverse order of removal.
Bolts for sunroof drive motor are micro-encapsulated and must always be replaced 3.5 Nm.
-
Perform a function test.