Passat Syncro Wagon V6-2.8L (ATQ) (2000)
Seat Heater Switch: Service and Repair
Switches In Instrument Panel Center Console, Removing And Installing
NOTE:
The procedure for removing and installing the
-
Emergency flasher switch -E3-
-
Rear window defogger switch -E15-
-
Seat heater regulator switches (modules -J131- and -J132-)
is essentially the same for all switches. Removing the emergency flasher switch -E3- is illustrated below.
Removing
CAUTION!
-
Be careful not to damage instrument panel center console trim when removing switch. Protect trim in area of switch with adhesive tape
before removing switch.
-
Do Not pry out switches from the side. Only pull out from the top.
-
Carefully loosen and remove switch faceplate using a plastic wedge tool (locally available) or wrapped screwdriver.
-
Using pliers, grasp switch at the top of the frame as illustrated and carefully pull switch from opening.
-
Disconnect electrical connector.
Installing
-
Connect electrical connector.
-
Insert switch into opening and push in to engage.
-
Install switch faceplate.