Passat Syncro Wagon V6-2.8L (ATQ) (2000)
Specification (display field 3): CAM-ADJ. ON
-
Also observe indication in display field 4.
Specification without adjustment: -3.0 to 3.0° KW
Specification with adjustment: 20.0 to 30.0° KW
Note:
Display field 4 indicates if the camshaft is actually being adjusted.
-
Press button -3- (VAG1551) or up arrow button (VAG 1552).
Indicated on display: (1 to 4 = display fields)
-
This measuring value block is valid for camshaft adjustment, cylinder bank 2:
-
Observe indication in display field 3.
Specification: CAM-ADJ. OFF
-
Accelerate vehicle in 1st gear from standstill.
With engine speed between 2000 and 5100 RPM (display field 1) and engine load above 58.0% (display field 2), camshaft adjustment must be active.
Specification (display field 3): CAM - ADJ. ON
Also observe indication in display field 4.
Specification without adjustment: -3.0 to 3.0° KW
Specification with adjustment: 20.0 to 30.0° KW
Note:
Display field 4 indicates if the camshaft actually being adjusted.
-
Press (arrow) button.
-
Press buttons -0- and -6- to select "End output" function 06 and press -Q- button to confirm input.
-
Switch ignition off.
If display field 4 indicates an adjustment value outside of specified range, the following malfunctions may be present:
The solenoid valves for camshaft adjustment are shifting oil pressure correctly to the relevant mechanical camshaft adjuster, but the adjuster cannot
reach its end position (e.g. difficulty of movement).
-
Replace camshaft adjuster(s).
If display field 3 and/or 4 indicates no adjustment
Replace camshaft adjuster(s).