Passat Syncro Wagon V6-2.8L (ATQ) (2000)
Valve Seat: Service and Repair
Valve seats, reworking
Special tools and equipment
-
Depth gauge
-
Valve seat refacing tool
Note:
-
When repairing engines with leaking valves, it is not sufficient to replace or replace valve seats and valves. It is also necessary to check the valve
guides for wear. This particularly important on high mileage engines.
-
The valve seats should only be reworked just enough to produce a perfect seating pattern. The maximum permissible reworking dimension must be
calculated before reworking commences. If the reworking dimension is exceeded, the function of the hydraulic lifters can no longer be guaranteed
and the cylinder head should be replaced.
The max. permissible reworking dimension is calculated as follows:
-
Insert valve and press firmly against seat.
Note: If the valve is to be replaced as part of a repair, use a new valve for the calculation.
-
Measure distance between end of valve stem and upper edge of cylinder head.
-
Calculate max. permissible reworking dimension from measured distance and minimum dimension.
Minimum dimension:
-
Outer inlet valve 34.0 mm
-
Center inlet valve 33.7 mm
-
Exhaust valve 34.4 mm
Measured distance minus minimum dimension = max. permissible reworking dimension.
Example:
The max. permissible reworking dimension is shown on illustrations for reworking valve seats as dimension "b".
Reworking inlet valve seat