Passat Syncro Wagon V6-2.8L (ATQ) (2000)
Specified value: 0.0 to at least 4.0 V, fluctuating
NOTE: The right front wheel must not turn during this, hold it steady if necessary.
If indicated voltage does not oscillate:
-
Remove instrument cluster:
-
Check wire connection from Engine Control Module (ECM) to Speedometer -G21- according to wiring diagram.
-
Erase DTC memory of Engine Control Module(ECM), Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes