Passat Syncro Wagon V6-2.8L (ATQ) (2000)
-
To remove the upper bolt of the transmission support, lower the transmission slightly and swing the exhaust pipe as far upward as possible.
-
Guide out front exhaust pipe with right / left catalytic converter toward rear.
Installing
CAUTION:
When doing any repair work, especially in the engine compartment, pay attention to the following due to clearance issues:
-
Route all the various lines (e.g. for fuel, hydraulics, EVAP system, coolant, refrigerant, brake fluid and vacuum lines and hoses) and electrical
wiring so that the original positions are restored.
-
Ensure sufficient clearance to all moving or hot components.
Installation is performed in reverse order. Note the following:
Vehicles with automatic transmission
-
Install transmission support and transmission mount.
-
Fasten subframe to body, See Suspension, Wheels, Steering
For vehicles with All Wheel Drive:
-
Fasten intermediate bearing of driveshaft to vehicle floor. Afterward, remove alignment fixture 3213 and tighten bolts using specified torque.
Continued for all vehicles
-
Secure oxygen sensor lines according to routing before removal.
-
Install front exhaust pipe with catalytic converter and oxygen sensors.
-
Install axle shaft shielding plates.
-
Install holding plate for intake manifold change-over valve.
-
Install intake air scoop.
-
Check Diagnostic Trouble Code (DTC) memory of all control modules, repair all stored malfunctions, and erase DTC memory afterward Vehicle
Diagnosis, Testing and Information System VAS 5051; Guided Fault Finding; Vehicle System Test, or Vehicle Diagnosis and Service Information
System VAS 5052; On Board Diagnostic (OBD).
-
Perform road test and check DTC memory of all control modules again.
NOTE: Observe safety precautions that apply to road tests.