Passat Syncro Wagon V6-2.8L (ATQ) (2000)
-
Select "08 - Read Measuring Value Block".
-
Enter "120" on keypad to select "Channel 120" .
-
Select "Q" button to confirm.
-
Start vehicle.
-
Fully apply brake pedal.
-
Shift transmission into "D".
WARNING:
Make sure that wheel chocks are in place and parking brake and brake pedal are fully applied, or personal injury may occur.
-
Slowly depress accelerator pedal until engine reaches 1600 RPM (white arrow), and torque reaches 120 Nm (black arrow).
NOTE:
Do not remain in above condition longer than 5 seconds, or torque converter damage may occur.
Under above condition:
-
Crankcase pressure must not be higher than 30 mbar (0.43 PSI).
If crankcase pressure exceeds 30 mbar (0.43 PSI):
-
Replace crankcase ventilation lines and suction jet pump, if applicable.
If crankcase pressure is below 30 mbar (0.43 PSI):
-
Clean oil-contaminated areas thoroughly.
-
Locate exact origin of any possible oil leak using an Engine Oil Leak Tracer (obtain locally).
-
Perform an extensive test drive to confirm any possible oil leak.
NOTE:
In case parts are replaced, perform an extensive test drive to verify that the oil leak has been eliminated.
Warranty
Information only
Required Parts and Tools
No Special Parts required