Passat Syncro Wagon V6-2.8L (ATQ) (2000)
It is essential that the installation position is marked -arrows- before the drive shaft is removed, offset installation will cause excessive
imbalance or vibration
-
Remove drive shaft from rear final drive
-
Pull out securing clip -1- and unhook parking brake cable from brake caliper
NOTE:
Do not damage parking brake boot when removing and installing
-
Loosen bolt -A- on both sides
-
Unhook parking brake cable -B- from retainer -C-
-
Repeat on opposite side
[NEW] TIP:
Mark position of rear sub-frame prior to removing bolts
-
Press locking tabs -A- together and push parking brake cable -2- out from control arm -1-
-
Remove control arm -1- from shock absorber by removing bolt -3-.
-
Repeat on opposite side
-
Remove securing bolts -arrows- from brake caliper housing, while holding guide pins