Passat Syncro Wagon V6-2.8L (ATQ) (2000)
^
Make certain arrow -1- on fuel tank and arrow -2- on sender cover are aligned.
Note:
For correct fuel sending unit operation the arrows on the fuel level sending unit cover and the fuel tank must be aligned as close as possible.
^
Reinstall locking ring for fuel level sending unit using the 3087 wrench and tighten to 120 Nm (89 ft. lbs.)
^
Reconnect harness connector to fuel level sending unit cover.
^
Proceed to Section E.
Section E - Installation of Fuel Sending Unit (Loc. -G237-)
^
Disconnect harness connector -arrow- on fuel level sending unit cover -G237- in luggage compartment.
^
Use the 2012A nut wrench and remove nut.
^
Lift fuel level sending unit, loosen seal on fuel tank and remove seal and fuel level sending unit from the fuel tank.