Passat Syncro Wagon V6-2.8L (ATQ) (2000)
Camshaft Position Sensor: Service and Repair
Removing seal on Camshaft Position sensor
-
Unscrew Camshaft Position (CMP) sensor.
-
Unscrew CMP rotor. Carefully pry rotor off camshaft when doing this.
-
Screw bolt 2085/1 into camshaft.
-
Unscrew inner part of oil seal extractor 2085 two turns (approximately 3 mm) out of outer part and lock with knurled screw.
-
Lubricate threaded head of oil seal extractor, place it in position and exerting firm pressure screw it as far as possible into oil seal.
-
Loosen knurled screw and turn inner part of extractor against camshaft until oil seal has been extracted.
Installing
-
Fit guide sleeve 3241/2 onto camshaft journal.
-
Slide dry seal over guide sleeve.
-
Press oil seal flush into cylinder head with press sleeve 3241/1 and the bolt 3241/3.
The rest of the assembly is basically a reverse of the disassembly sequence.