Passat Syncro Wagon V6-2.8L (ATQ) (2000)
19. 25 Nm (18 ft. lbs.)
20. Mounting bracket
21. Suction line with hose
22. 8 Nm (70 inch lbs.)
Removing:
-
Removing upper engine cover - Fig. 1.
-
Removing ribbed belt guard - Fig. 2.
-
Relieving tension on ribbed belt - Fig. 3.
-
Remove belt pulley; counterhold with VAG 1590 if necessary
-
Pull ignition wire out of ignition coils -10-.
-
Clamp off suction hose with 3094 or equivalent.
-
Disconnect suction and pressure lines.
-
Unbolt bracket, item -9-, and remove complete with power steering pump.
-
Remove pump to bracket bolts and remove pump.
Installing: Install in reverse order.
Note: Ignition wire application must equate to numbers marked - Fig. 4
Fig. 1 Uncapping top engine cover and removing
Fig. 2 Removing ribbed belt guard
Fig. 3 Relieving tension and removing ribbed belt
-
Push tool downward to relieve tension on ribbed belt.
-
Align hole -A- with hole -B-.
-
Insert pin 3204 to secure.
-
Remove ribbed belt from belt pulley.