Passat Syncro Wagon V6-2.8L (ATQ) (2000)
-
Pull in bonded rubber mounting until chamfer (arrows) is positioned at edge of mounting hole.
-
Check that chamfer is positioned evenly all around. Reposition if necessary.
-
Slowly pull in bonded rubber mounting until completely installed.
Note: The tools and the bonded rubber mounting must be guided by a second technician during the installation.
Installing axle beam
The arrows on the bonded rubber mounting aluminum washers must point to the rear.
1. Bolt
^
110 Nm (81 ft. lbs.) + 90°
Always use new bolts!
2. Aluminum washer for front bonded rubber mounting
3. Aluminum washer for rear bonded rubber mounting
-
Tighten bolts for axle beam to 110 Nm (81 ft. lbs.) + 90°.